Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 555

For e series broadband services routers - broadband access
Table of Contents

Advertisement

host1(config)# run show policy-list dot1pToUpc
VLAN Policy dot1pToUpc
Administrative state: enable
Reference count:
Classifier control list: dot1p0, precedence 100
user-packet-class 0
Classifier control list: dot1p1, precedence 100
user-packet-class 1
Classifier control list: dot1p2, precedence 100
user-packet-class 2
Classifier control list: dot1p3, precedence 100
user-packet-class 3
Classifier control list: dot1p4, precedence 100
user-packet-class 4
Classifier control list: dot1p5, precedence 100
user-packet-class 5
Classifier control list: dot1p6, precedence 100
user-packet-class 6
Classifier control list: dot1p7, precedence 100
user-packet-class 7
Referenced by interface(s):
None
Referenced by profile(s):
atm1483BaseProfile
Referenced by merged policies:
None
Configure the DHCP relay to use the option 82 suboptions. This configuration
3.
includes the command that specifies the mapping of the user packet class values
from the layer 2 policy to the user-packet-class type in the option 82
Vendor-Specific suboption.
host1(config)# set dhcp relay 192.168.32.1 proxy
host1(config)# set dhcp relay 192.168.32.2
host1(config)# set dhcp relay agent sub-option circuit-id
host1(config)# set dhcp relay agent sub-option remote-id
host1(config)# set dhcp relay agent sub-option vendor-specific
user-packet-class
host1(config)# set dhcp relay agent sub-option vendor-specific
layer2-circuit-id
host1(config)# set dhcp relay options hostname
host1(config)# set dhcp relay options exclude-subinterface-id
host1(config)# set dhcp relay inhibit-access-route-creation
host1(config)# set dhcp relay trust-all
host1(config)# set dhcp relay override agent-option
(Optional) Verify the DHCP Relay configuration.
4.
host1(config)# run show dhcp relay
DHCP Relay Configuration
------------------------
Mode: Proxy
Chapter 20: Configuring DHCP Relay
Policy Table
------ -----
1
input policy, statistics enabled
Configuring DHCP Relay and BOOTP Relay
515

Advertisement

Table of Contents
loading

Table of Contents