JUNOSe 11.1.x Broadband Access Configuration Guide
tacacs-server source-address
tacacs-server timeout
328
Configuring TACACS+ Support
host1(config)#tacacs-server key &# 889khj
Use the no version to reset a key value shared by all TACACS+ servers.
See tacacs-server key
Use to set or reset an alternative source address to be used for TACACS+ server
communications.
Existing connections are not affected by this command.
Example
host1(config)#tacacs-server source-address 192.168.134.63
Use the no version to remove the address.
See tacacs-server source-address
Use to set the interval in seconds that the server waits for the server host to
reply. The specified interval is shared by all TACACS+ servers that do not have
a server-specific timeout set up by tacacs-server host command.
The timeout interval is between 1 and 300. The default is 5 seconds.
Example
host1(config)#tacacs-server timeout 15
Use the no version to reset the timeout to the default.
See tacacs-server timeout