Library Settings - Spectra Logic T-Series Spectra T50e User Manual

L S
IBRARY ETTINGS
This section describes how to modify the library's general configuration
settings.
Entering the Library Settings
Follow these steps to configure the library name, refresh rate, web server
port, online access, and automatic configuration save settings:
1. Log in as a user in either the superuser or administrator group (see
2. Select Configuration > Settings. The Settings screen appears.
3. Enter the library name in the Library Name field.
4. Use the Refresh Rate drop-down menu to select the LC's refresh rate.
5. If you want to change the Web server port for security reasons, enter
You must power cycle the library after changing the web server port. Ensure that
Caution
there are no backups running prior to the power cycle.
December 2008
Configure Library Users on page 73
Figure 51 The Settings screen.
The library name is purely for user reference. It shows up on the RLC to
identify the library at which you are looking, as well as on the results
screens for utilities and traces.
Note that the LC can be refreshed at any time by selecting the refresh
icon on the status bar.
your Web server port in the Web Server Port field.
Note: If you wish to access the library remotely using the RLC once
you've changed the Web server port, you must enter a colon (:)
after the library's IP address and then the new port number.
to learn how to setup users groups).
Refresh icon

Library Settings

Spectra T50e library
81