Spectra Logic T-Series Spectra T50e User Manual page 47

Connecting Fibre Channel Tape Drives
In a Fibre Channel environment, you can connect the tape drive(s) to a
Fibre Channel hub or switch in an arbitrated loop or a switched fabric or
directly to the host or HBA. For simplicity in these instructions, each of
these situations is referred to as a "network."
1. Remove the protective plug from the optical connector on the drive sled.
2. Remove the protective plugs from the cable connectors
December 2008
Note:
It is not necessary to power off the host computer when
connecting Fibre Channel tape drives.
For information on World Wide Node Names (WWNN)
and World Wide Port Names (WWPN), see
Channel WWN Naming Conventions on page
Figure 19 LC Optical Cable.
Connect the Tape Drives
LTO-4 Fibre
234.
(Figure 19).
Plugs
Spectra T50e library
47