Chapter 2 - Library Installation; Prepare For The Installation - Spectra Logic T-Series Spectra T50e User Manual

This chapter describes how to install the library and log into the user
interface.
P
REPARE FOR THE
Check the Location and Host
Before unpacking and installing the library, confirm the following:
Environment-Ensure that the environment where you plan to install the library is prepared for the unit.
ESD Ensure that the work area is free from conditions that could cause electrostatic
discharge (ESD). Discharge static electricity from your body by touching a known
grounded surface, such as a computer's metal chassis.
Acclimation If the temperature in the room where the library will be installed varies by 30° F
(15° C), from the location where the library was stored, allow the library to acclimate to
the new temperature for a minimum of 12 hours before unpacking the library.
Task
Prepare for the Installation
Unpack the Library
Install the Library
Install the Tape Drives
Connect the Tape Drives
Connect the Library to an Ethernet Network
Connect the AC Power
Power On the Library
Log Into the User Interface
I
NSTALLATION
Chapter 2
Library Installation
29
Described on...
page 29 below
page 32
page 36
page 42
page 45
page 49
page 50
page 51
page 51