Spectra Logic T-Series Spectra T50e User Manual page 127

2. If you select Hard addressing for Fibre Channel tape drives, use the +
3. Proceed to
Confirming and Saving Partition Settings
After you finish configuring the partition, confirm and save the partition.
1. From the Drive IDs screen, select Next. The Save Library Configuration
2. Select whether to save the current library configuration. Spectra Logic
December 2008
A loop ID that corresponds to each Fibre Channel tape drive's type
Figure 100 The Drive IDs screen for Fibre Channel tape
drives.
and – to select a unique loop ID for each tape drive.
Confirming and Saving Partition
screen displays (Figure
Figure 101 The Save Library Configuration screen.
recommends saving your partition configuration settings.
If you want to save the configuration, choose whether to save it to USB
or to email it to an already-configured mail recipient (see
Mail Users on page 84).
Note: If you want to save the configuration to a USB memory device,
connect the device to the USB port on the LCM (see
page 27) before continuing.
Settings.
101).
Spectra T50e library
Create a New Partition
Configuring
Figure 10 on
127