Power Specifications; Input Power Requirements; Power Cord Specifications - Spectra Logic T-Series Spectra T50e User Manual

Power Specifications

This section describes the power specifications for the library.

Input Power Requirements

The following table shows the input power requirements for the library
with one to four LTO tape drives installed. Each input must be protected
by a circuit breaker rated for 15 amps.
a. Requires a 220–240 VAC AC power cord with a twist-lock male connector. See

Power Cord Specifications

The power cords included with the library is considered part of the library
and cannot be used with any other equipment.
The power cords included with library is standard, three conductor, 18
AWG AC power cords safe for 100-volt to 130-volt use in the United States
and Canada. The cable has a molded NEMA 5-15P male connector to plug
into the wall and a molded IEC type CEE-22 female connector to plug into
the library.
Power Consumption and Cooling Requirements
The power and cooling requirements for the library depend on the number
and type of tape drives installed. The following table provides the nominal
and maximum power consumption specifications for the library.
December 2008
Electrical Rating
100–127 VAC, 50/60 Hz
200–240 VAC, 50/60 Hz
<TableItalics>Power Cord Specifications on page 229 for detailed information about
power cord requirements.
Note: To use the library outside of North America, the power cord
must meet the specifications for that country.
Parameter Specification
Power Maximum: 350 watts (continuous power input)
Consumption
Heat Load Maximum: 1195 BTU/hour (continuous)
Current Rating (Maximum)
4 amps per cord
a
2 amps per cord
Library Specifications
Spectra T50e Library
229