Place The Library In The Rack - Spectra Logic T-Series Spectra T50e User Manual

4. Using a #2 Phillips screwdriver, install four M6 screws—two in the
5. Repeat Steps 1 through 3 to install the right-side rail.

Place the Library in the Rack

The library weighs approximately 34.4 lb. (15,6 kg).
Warning
Two people are needed to move or lift the library. Most of the
weight is toward the back of the library.
German: Der Library hat ein Gewicht von ungefähr 15,6 kg
(34.4 lb). Zwei Personen sind notwendig, zu verschieben oder
Aufhebung der Library. Die schwersten Komponenten
befindern sich im hinteren Teil der Library.
Do not install the rubber feet if you are installing the library in a rack, as they are
Important
meant for a tabletop installation only! See
description of the rubber feet.
1. Lift the library onto the shelf formed by the rails.
2. Slide the library completely into the rack so that the mounting brackets
December 2008
front and two in the rear—to secure the rail to the rack
Tighten the screws securely.
Note: Two sets of M6 screws are provided. The type you use depends
on the type of rack you have. Use the screws with the larger
shoulder for racks with square holes.
To simplify the installation, have a second person support
the rail while you install the screws.
Leave the middle hole in each rail empty. You will use
them when attaching the library's mounting brackets to
the rack.
Note: Make sure you install the right-side rail at the same level as the
left-side rail so that the shelves on both are level from right to
left. Otherwise the library will not be level when installed in the
rack. Use a level to verify that the rail is level from front to back
and the shelf formed by the rails is level from left to right.
are against the posts.
Tabletop Installation on page 40
Spectra T50e library
Install the Library
(Figure 13, ).
3
for a
39