Spectra Logic T-Series Spectra T50e User Manual page 31

Drivers and Ensure that any necessary device drivers and the backup software are compatible with
Software the library and the tape drive(s).
Note: The software can be installed on the host computer before or after library
installation. However, if the software is installed first, it may be necessary to
reconfigure it for use with the library after library installation is complete.
Host
When installing a library with SCSI tape drives, the host computer(s) must be powered
down. If they are on a network, check with the network administrator before powering
them down.
Note: Compatibility information is available at: www.spectralogic.com/compatibility.
Check the Accessories
Make sure you have the accessories listed in the following table.
Accessory
Cartridges
Interface cables and
accessories
December 2008
Description
Use only data cartridges and cleaning cartridges designed
specifically for LTO Ultrium tape drives. For more
information, see:
LTO Media Specifications on page 235
Certified Media on page 215
SCSI Cable
(SCSI tape drives only)—
LTO-3 SCSI
:
For each LTO-3 SCSI tape drive you need one high-
density (HD), wide (68-pin), LVD SCSI cable.
If your SCSI controller has a 68-pin very high-density
(VHDCI) connector, you will need to obtain a VHDCI-to-
HD SCSI cable.
LTO-4 SCSI
:
For each LTO-4 SCSI tape drive, you need a 68-pin
VHDCI SCSI cable.
SCSI Terminator
(SCSI tape drives only)—
LTO-3 SCSI
: one wide Ultra 3 Active SCSI terminator is
required for each SCSI bus you will connect to the library.
Use a high-quality active SCSI terminator rated for Ultra 3.
An appropriate terminator is stamped with Ultra 3 or LVD
160 and "Active Negation."
LTO-4 SCSI
: use a VHDCI terminator.
Note: Both LTO-3 and LTO-4 tape drives require an Ultra 3
or LVD 320 terminator to function properly on the SCSI
bus. An inadequate terminator will result in various SCSI
bus issues, including bus hangs and Read/Write failures.
Prepare for the Installation
Spectra T50e library
31