Connecting A Fiber-Optic Cable To An Ex Series Switch - Juniper EX3200 Series Complete Hardware Manual

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches
Related Topics

Connecting a Fiber-Optic Cable to an EX Series Switch

158
NOTE: Most modems have an RS-232 DB-25 connector. You must separately purchase
an adapter to connect your modem to the RJ-45 to DB-9 adapter and Ethernet cable
supplied with the switch.
To connect a modem to the console port:
Turn off power to the switch.
1.
Turn off power to the modem.
2.
Connect one end of the cable to the console port (labeled
3.
switch.
For the location of the console port on different EX Series switches:
See Rear Panel of an EX2200 Switch.
See "Rear Panel of an EX3200 Switch" on page 8.
See "Rear Panel of an EX4200 Switch" on page 11.
See Front Panel of an EX4500 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
Connect the other end of the cable to the RJ-45 to DB-9 serial port adapter supplied
4.
with your switch.
Connect the serial port adapter to the DB-9 female to DB-25 male adapter or other
5.
adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
6.
Connect one end of the phone cable to the modem and the other end to your
7.
telephone network.
Turn on the power to your modem.
8.
Power on the switch.
9.
Connecting an EX Series Switch to a Management Console on page 153
Console Port Connector Pinout Information for an EX Series Switch on page 41
EX Series switches have field-replaceable unit (FRU) optical transceivers to which you
can connect fiber-optic cables.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in an
EX Series switch, ensure that you have taken the necessary precautions for safe handling
CON or CONSOLE ) on the
Copyright © 2010, Juniper Networks, Inc.