Table of Contents
Advertisement
M
1
6
C
2 /
6
A
G
o r
u
p
(
M
1
6
19.7.1.3 Timer A (One-shot Timer Mode)
1. The timer remains idle after reset. Set the mode, count source, counter value, etc. using the TAiMR
(i = 0 to 4) register, the TAi register, the TA0TGL and TA0TGH bits in the ONSF register and the
TRGSR register before setting the TAiS bit in the TABSR register to "1" (count starts).
Always make sure the TAiMR register, the TA0TGL and TA0TGH bits and the TRGSR register are
modified while the TAiS bit remains "0" (count stops) regardless whether after reset or not.
2. When setting TAiS bit to "0" (count stop), the following occur:
• The counter stops counting and the content of reload register is reloaded.
• TAi
pin outputs "L".
OUT
• After one cycle of the CPU clock, the IR bit in the TAiIC register is set to "1" (interrupt request).
3. Output in one-shot timer mode synchronizes with a count source internally generated. When the
external trigger has been selected, a maximun delay of one cycle of the count source occurs be-
tween the trigger input to TAi
4. The IR bit is set to "1" when timer operation mode is set with any of the following procedures:
• Select one-shot timer mode after reset.
• Change the operation mode from timer mode to one-shot timer mode.
• Change the operation mode from event counter mode to one-shot timer mode.
To use the timer Ai interrupt (the IR bit), set the IR bit to "0" after the changes listed above have
been made.
5. When a trigger occurs while the timer is counting, the counter reloads the reload register value, and
continues counting after a second trigger is generated and the counter is decremented once. To
generate a trigger while counting, space more than one cycle of the timer count source from the first
trigger and generate again.
6. When selecting the external trigger for the count start conditions in timer A one-shot timer mode, do
generate an external trigger 300ns before the count value of timer A is set to "0000
timer does not continue counting and may stop.
7. If a low-level signal is applied to the SD pin when the IVPCR1 bit in the TB2SC register is set to "1"
(three-phase output forcible cutoff by input on SD pin enabled), the TA1
pins go to a high-impedance state.
R
e
. v
2
0 .
0
F
e
b
1 .
, 5
2
0
0
7
R
E
J
0
9
B
0
2
0
2
0 -
2
0
0
C
2 /
6
, A
M
1
6
C
2 /
6
, B
M
1
6
pin and output in one-shot timer mode.
IN
page 309
f o
3
2
9
C
2 /
6
) T
_____
_____
19. Usage Notes
". The one-shot
16
, TA2
and TA4
OUT
OUT
OUT
Advertisement
Table of Contents
