Table of Contents
Advertisement
Intermec 3270 or 5250 Emulation This Intermec software allows your device to
emulate an IBM 3270 or 5250 terminal using a telnet session.
Note: The UDP+ option is for communication with the Model 200 Controller.
Novell TNVTxxx Emulation Select this option to configure your JANUS device to
emulate a VT120/220/320 or ANSI terminal using a telnet session. You may
also need to load an application when running this emulation.
NetWare Client for DOS This Novell software allows your device to run your
applications using SPX/IPX protocol.
FTP PC/TCP Stack This TCP/IP stack allows your JANUS device to run
applications using the PC/TCP stack from FTP Corporation.
Note: To install the FTP PC/TCP stack you will need to purchase the FTP PC/TCP
Stack Disk (P/N 067791). See your Intermec sales representative to order the FTP disk.
Character Set Screen
The Choose a Character Set selection screen configures your JANUS RF device
for the selected character set.
The Installation Utility supports international character sets for France,
Germany, Italy, and Spain. The default BIOS keyboard driver supports the U.S.
character set. An international character set allows DOS to display date and
time prompts, currency symbols, date separators, time separators, and decimal
separators in the standard format of the chosen country. The international
character set drivers do not translate DOS message text.
If you select a non-U.S. character set, these actions are performed when the
CONFIG.SYS file is processed:
The COUNTRY configuration command is executed, which customizes
country-dependent information (such as date and time formats, currency
symbols, collating sequences, etc.) for a particular country.
The DISPLAY.SYS device driver is loaded to support code page (character
set) switching for the console device (LCD).
Preparing to Run the Installation Utility
2
2-5
Advertisement
Table of Contents
