JANUS 2010 Hand-Held Computer User's Manual (4MB)
code39
nugget
EOF (End of File) (continued)
Or:
To set EOF to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
EOM (End of Message)
Purpose:
Attaches an EOM to the end of a data block to indicate the end of data
transmission to and from a reader. You can disable the EOM transmit and
receive characters, define EOM transmit and receive to the same characters, or
define EOM transmit and receive to different characters.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default:
EOM Transmit and Receive are set to CR (0DH) and LF (0AH)
(carriage return line feed)
PF
Syntax:
PFdata
PI
PIdata
PJ
PJdata
where data can be one or two ASCII characters.
12-52
helconital
Enter Accumulate Mode / Set EOF
*+/$+FA*
*+/$+FA*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Disable EOM transmit and receive
Enable EOM transmit and receive
Disable EOM transmit only
Enable EOM transmit only
Disable EOM receive only
Enable EOM receive only