Flash; Beeping Sounds; Overriding Default Boot Drive - Intermec 6200 Troubleshooting Manual

" " " " " " "

Beeping Sounds

Beeping sounds occur after pressing the reset switch to test extended
memory in the computer. If all extended memory is allocated to a RAM
drive, there is no beeping.

Overriding Default Boot Drive

To boot from drive A: or B:, have a PC Card in that slot. To boot from a
drive other than the default drive:
Another way to set a new default boot drive is through the NORAND
Utilities program when the computer is already in drive D:\:
" " " " " " "
1. Press the reset switch. The computer should make beep sounds.
2. Repeatedly press the [F4] key until the computer beeps.
3. Immediately hold down the [F4] key before the beeping stops. Con-
tinue to hold the [F4] key until the ROM DOS 5 Boot Menu appears
at the bottom of the screen.
4. Press the number for the desired boot drive.
1. Access the NORAND Utilities program.
2. Press [9] for the Advanced Utilities
3. Press [5] to set the new default boot drive.
4. Press the reset switch.
6200 and 6210 Hand-Held Computers Troubleshooting Guide 3-1
" " " " " " "
Section 3

Flash

" " " " " " "
