Table of Contents
Advertisement
Diagnostics
iii. To change the status interval:
(config)> system log event dhcpserver status_interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set the status interval to ten minutes, enter either 10m or 600s:
(config)> system log event dhcpserver status_interval 600s
(config)>
6. (Optional) See
servers to which log messages will be sent.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
Configure syslog servers
for information about configuring remote syslog
Configure options for the event and system logs
778
Advertisement
Table of Contents
