Table of Contents
Advertisement
Interfaces
12. Optional active recovery configuration parameters:
a. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
b. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
c. For Pass threshold, type or select the number of times that the test must pass after
failure, before the interface is determined to be working and is reinstated.
d. For Failed attempts, type the number of probe attempts before the WAN is considered to
have failed.
e. For Response timeout, type the amount of time that the device should wait for a response
to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
13. (Optional) Repeat this procedure for IPv6.
14. Click Apply to save the configuration and apply the change.
Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface, or edit an existing one:
To create a new interface, see
n
To edit an existing interface, change to the interface's node in the configuration
n
schema. For example, for a interface named my_wwan, change to the my_wwan node
in the configuration schema:
IX10 User Guide
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Wireless Wide Area Networks (WWANs)
Configure a Wireless Wide Area Network
(WWAN).
83
Advertisement
Table of Contents
