Digi IX10-00G4 User Manual page 341

Virtual Private Networks (VPN)
IX10 User Guide
(Optional) Set the amount of time to wait for an initial connection to the
l
interface before this test is considered to have failed:
(config vpn openvpn client openvpn_client1 surelink target
0)> interface_timeout value
(config vpn openvpn client openvpn_client1 surelink target
0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s:
(config vpn openvpn client openvpn_client1 surelink target
0)> interface_timeout 600s
(config vpn openvpn client openvpn_client1 surelink target
0)>
The default is 60 seconds.
other: Allows you to test another interface's status, to create a failover or
l
coupled relationship between interfaces:
(config vpn openvpn client openvpn_client1 surelink target
0)> other value
(config vpn openvpn client openvpn_client1 surelink target
0)>
If other is set:
Set the alternate interface to be tested:
o
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn openvpn client openvpn_client1 surelink
target 0)> other_interface /network/interface/eth1
(config vpn openvpn client openvpn_client1 surelink
target 0)>
Set the alternate interface's IP version. This allows you to determine the
o
alternate interface's status for a particular IP version.
(config vpn openvpn client openvpn_client1 surelink target
0)> other_ip_version value
(config vpn openvpn client openvpn_client1 surelink target
0)>
where value is one of: any, both, ipv4, or ipv6.
Set the expected status of the alternate interface:
o
(config vpn openvpn client openvpn_client1 surelink target
0)> other_status value
OpenVPN
341