Table of Contents
Advertisement
Serial port
esac
done
16. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
17. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure RealPort mode
You can configure the IX10 to communicate with your computer using RealPort.
Note
If you are using the Windows OS, you can also enable and configure RealPort mode for the IX10
device and your computer from the Digi Navigator. See
Step 1: Install Realport
You can install RealPort on a computer with either a Windows OS or a Linux OS.
Windows: For the Windows installation process, see
n
Linux: For the Linux installation process, refer to the
n
the RealPort Installation User's Guide.
Step 2: Configure the serial ports for RealPort mode
You should perform this process on each of the serial ports on the device. See
port for RealPort
Step 3: Configure the RealPort service
To complete RealPort configuration on the IX10, you must enable and configure the RealPort service.
See
Configure the RealPort
Install RealPort on a Windows computer
You must download and run the RealPort utility.
Step 1: Download and run Digi Device Discovery Utility
1. Navigate to www.digi.com/support/realport.
2. From the Operating System Specific Drivers list box, select the appropriate Microsoft
Windows option. A list of driver options appears.
3. Click the desired RealPort for Windows version. The file is downloaded, and a Windows
Explorer window launches, showing the RealPort files.
4. When the download is complete, open the .zip file and click the setup.exe file. The Digi
RealPort Setup Wizard appears.
IX10 User Guide
mode.
service.
Configure RealPort mode
Digi Navigator
application.
Install RealPort on a Windows
Get started: Install RealPort for LINUX
Configure the serial
computer.
in
180
Advertisement
Table of Contents
