Digi IX10-00G4 User Manual page 843

Command line interface
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, create a new user with the username user1:
Method one: Create a user at the root of the config prompt:
n
(config)> add auth user user1
(config auth user user1)>
Method two: Create a user by moving through the configuration:
n
a. At the config prompt, enter auth to move to the auth node:
b. Enter user to move to the user node:
c. Create a new user with the username user1:
4. Configure a password for the user:
(config auth user user1)> password pwd1
(config auth user user1)>
5. List available authentication groups:
(config auth user user1)> show .. .. group
admin
acl
IX10 User Guide
(config)> auth
(config auth)>
(config auth)> user
(config auth user)>
(config auth user)> add user1
(config auth user user1)>
admin
enable true
nagios
enable false
openvpn
enable false
no tunnels
portal
enable false
Configuration mode
843