Table of Contents
Advertisement
User authentication
12. (Optional) For Group attribute, type the name of the user attribute that contains the list of
IX10 authentication groups that the authenticated user has access to. See
configuration
13. For Timeout, type or select the amount of time in seconds to wait for the LDAP server to
respond. Allowed value is between 3 and 60 seconds.
14. Add LDAP to the authentication methods:
a. Click Authentication > Methods.
b. For Add method, click .
c. Select LDAP for the new method from the Method drop-down.
Authentication methods are attempted in the order they are listed until the first successful
authentication result is returned. See
information about rearranging the position of the methods in the list.
15. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Prevent other authentication methods from being used if LDAP authentication fails.
Other authentication methods will only be used if the LDAP server is unavailable.
(config)> auth ldap authoritative true
(config)>
4. Set the type of TLS connection used by the LDAP server:
(config)> auth ldap tls value
(config)>
where value is one of:
IX10 User Guide
for further information about the group attribute.
Rearrange the position of authentication methods
LDAP
LDAP user
for
631
Advertisement
Table of Contents
