Digi IX10-00G4 User Manual page 144

Interfaces
f. Set the IP address or host name of the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced nftp_
server ip_address
(config)>
g. Set the relative path and file name of the bootfile on the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootfile
filename
(config)>
8. See Configure DHCP options
9. See Map static IP addresses to hosts
10. Save the configuration and apply the change:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Map static IP addresses to hosts
You can configure the DHCP server to assign static IP addresses to specific hosts.
Required configuration items
IP address that will be mapped to the device.
n
MAC address of the device.
n
Additional configuration items
A label for this instance of the static lease.
n
To map static IP addresses:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
IX10 User Guide
for information about custom DHCP options.
for information about static leases.
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
144