Table of Contents
Advertisement
System administration
c. For Duration window, select the amount of time that the maintenance tasks will
d. For Frequency, select whether the maintenance window will be started every day,
If Check if Python Out-of-Service is set, the maintenance window will only start if the
n
Python Out-of-Service is set. See
information.
7. (Optional) Click to enable Device firmware update to instruct the system to look for any
updated device firmware during the maintenance window. If updated firmware is found, it will
then be installed.
Note
If your device is managed by a Digi Remote Manager configuration, the configuration
manages the device's firmware version. You should not enable this option.
8. (Optional) Click to enable Modem firmware update to instruct the system to look for any
updated modem firmware during the maintenance window. If updated firmware is found, it
will then be installed. Modem firmware update looks for updated firmware both on the local
device and over the network, using either a WAN or cellular connection.
9. (Optional) Click to enable Configuration check to allow for the configuration to be updated,
including by custom scripts, during the maintenance window.
10. (Optional) Configure automated checking for device firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables to automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX10 User Guide
If Duration window is set to any value other than to Immediately or 24 hours,
l
the maintenance tasks will run at a random time during the time allotted for
the duration window.
If Duration window is set to one or more hours, the minutes field in Start time
l
is ignored and the duration window will begin at the beginning of the specified
hour.
be run. If Immediately is selected, all scheduled tasks will begin at the exact time
specified in Start time.
or once per week.
Schedule system maintenance tasks
Use Python to set the maintenance window
for further
732
Advertisement
Table of Contents
