Table of Contents
Advertisement
User authentication
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LDAP
Your IX10 device supports LDAP (Lightweight Directory Access Protocol), a protocol used for directory
information services over an IP network. LDAP can be used with your IX10 device for centralized
authentication and authorization management for users who connect to the device. With LDAP
support, the IX10 device acts as an LDAP client, which sends user credentials and connection
parameters to an LDAP server. The LDAP server then authenticates the LDAP client requests and sends
back a response message to the device.
When you are using LDAP authentication, you can have both local users and LDAP users able to log in
to the device. To use LDAP authentication, you must set up a LDAP server that is accessible by the
IX10 device prior to configuration. The process of setting up a LDAP server varies by the server
environment.
This section contains the following topics:
LDAP user configuration
LDAP server failover and fallback to local configuration
Configure your IX10 device to use an LDAP server
IX10 User Guide
LDAP
627
628
628
626
Advertisement
Table of Contents
