Table of Contents
Advertisement
System administration
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a system maintenance trigger:
a. Add a trigger:
(config)> add system schedule maintenance trigger end
(config)>
b. Set the type of trigger:
(config add system schedule maintenance trigger)> type value
(config)>
where value is one of:
n
n
n
IX10 User Guide
interface_up: If interface_up is set:
i. Set the interface:
(config add system schedule maintenance trigger)> interface
value
(config)>
ii.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config system schedule maintenance trigger 0)> interface
/network/interface/eth1
(config system schedule maintenance trigger 0)>
out_of_service: The maintenance window will only start if the Python Out-of-
Service is set. See
Use Python to set the maintenance window
information.
time: Configure a time period for the maintenance window:
i. Configure the time of day that the maintenance window should start, using the
syntax HH:MM. If the start time is not set, maintenance tasks are not scheduled
and will not be run.
(config system schedule maintenance trigger 0)> time from
HH:MM
(config system schedule maintenance trigger 0)>
The behavior of the start time varies depending on the setting of the duration
length, which is configured in the next step.
If the duration length is set to 0, all scheduled tasks will begin at the exact
l
time specified in the start time.
If the duration length is set to 24 hours, the start time is effectively
l
obsolete and the maintenance tasks will be scheduled to run at any time.
Schedule system maintenance tasks
for further
733
Advertisement
Table of Contents
