Table of Contents
Advertisement
Routing
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new VRRP instance, or edit an existing one. See
creating a new VRRP instance.
4. Enable VRRP+:
(config)> network vrrp VRRP_test vrrp_plus enable true
(config)>
5. Add interfaces to monitor. Generally, this will be a cellular or WAN interface.
a. Use the ? to determine available interfaces:
b. Set the interface, for example:
(config)> add network vrrp VRRP_test vrrp_plus monitor_interface end
/network/interface/modem
(config)>
c. (Optional) Repeat for additional interfaces.
6. Set the amount that the device's priority should be decreased or increased due to SureLink
connectivity failure or success:
(config)> network vrrp VRRP_test vrrp_plus weight value
(config)>
where value is an integer between 1 and 254. The default is 10.
Along with the priority settings for devices in this VRRP pool, the amount entered here should
be large enough to automatically demote a master device when SureLink connectivity fails. For
example, if the VRRP master device has a priority of 100 and the backup device has a priority
IX10 User Guide
Virtual Router Redundancy Protocol (VRRP)
Configure VRRP
for information about
237
Advertisement
Table of Contents
