Table of Contents
Advertisement
Interfaces
6. For Active SIM slot, select the SIM slot that should be used by the modem, or select Any to use
any SIM slot. The default is Any.
7. If Active SIM slot is set to Any, for Preferred SIM slot, select the SIM slot that should be
considered the preferred slot for this modem, or select None. In the event of a failover to a
non-preferred SIM, or if manual SIM switching is used to switch to a non-preferred SIM, the
modem will attempt to reconnect to the SIM in the preferred SIM slot. None is the default.
8. For Maximum number of interfaces, type the number of interfaces that can be configured to
use this modem. This is used when using
9. Enable Carrier switching to allow the modem to automatically match the carrier for the active
SIM. Carrier switching is enabled by default.
10. For Access technology, select the type of cellular technology that this modem should use to
access the cellular network, or select All technologies to configure the modem to use the best
available technology. The default is All technologies.
11. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,
or both the main and auxiliary antennas.
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Modem configurations are enabled by default. To disable:
(config)> network modem modem enable false
(config)>
4. Set the matching criteria used to determine if this modem configuration applies to the
currently attached modem:
(config)> network modem modem match value
(config)>
where value is one of the following:
any: Applies this configuration to any modem that is attached.
n
imei: Applies this configuration only to a modem that matches the identified IMEI.
n
l
IX10 User Guide
If imei is used, set the IMEI of the modem that this configuration should be applied
to:
(config)> network modem modem imei value
(config)>
where value is the IMEI of the modem.
Wireless Wide Area Networks (WWANs)
dual-APN
SIMs. The default is 1.
94
Advertisement
Table of Contents
