Table of Contents
Advertisement
Services
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example performance test using iPerf3
On a remote host with Iperf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the IX10 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[
4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[
4]
0.00-1.00
[
4]
1.00-2.00
[
4]
2.00-3.00
[
4]
3.00-4.00
[
4]
4.00-5.00
[
4]
5.00-6.00
IX10 User Guide
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Transfer
sec
26.7 MBytes
sec
28.4 MBytes
sec
29.8 MBytes
sec
31.2 MBytes
sec
32.1 MBytes
sec
32.5 MBytes
Configure the ping responder service
Bandwidth
Retr
224 Mbits/sec
8
238 Mbits/sec
29
250 Mbits/sec
0
262 Mbits/sec
0
269 Mbits/sec
0
273 Mbits/sec
0
Cwnd
2.68 MBytes
1.39 MBytes
1.46 MBytes
1.52 MBytes
1.56 MBytes
1.58 MBytes
520
Advertisement
Table of Contents
