Table of Contents
Advertisement
Services
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use the iPerf service
Your IX10 device includes an iPerf3 server that you can use to test the performance of your network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues, to determine, for example, whether a
cellular connection is providing expected throughput.
The IX10 implementation of iPerf3 supports testing with both TCP and UDP.
Note
Using iPerf clients that are at a version earlier than iPerf3 to connect to the IX10 device's iPerf3
server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the IX10 device's iPerf3 server.
IX10 User Guide
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Use the iPerf service
511
Advertisement
Table of Contents
