Table of Contents
Advertisement
System administration
2. Disable encryption with the following command:
> system disable-cryptography
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Re-enable cryptography after it has been disabled.
To re-enable cryptography:
1. Configure your PC network to connect to the 192.168.210 subnet. For example, on a Windows
PC:
a. Select the Properties of the relevant network connection on the Windows PC.
b. Click the Internet Protocol Version 4 (TCP/IPv4) parameter.
c. Click Properties. The Internet Protocol Version 4 (TCP/IPv4) Properties dialog appears.
d. Configure with the following details:
n
n
IX10 User Guide
IP address for PC: 192.168.210.2
Subnet: 255.255.255.0
Disable device encryption
736
Advertisement
Table of Contents
