Digi IX10-00G4 User Manual page 24

Digi IX10 Quick start
be used as an alternative.
c. Once the surface is clean and dry, apply a small amount of dielectric grease in a thin layer
over the contacts. Use a new cotton-tipped applicator to work the grease smoothy over
the contacts. Apply gentle pressure.
d. When the dielectric grease has been applied, insert the SIM into the SIM slot as described
above.
2. Attach cellular antennas
Securely tighten each antenna using the barrel connector at the base of the antenna.
3. Connect DC power
4. Wait until a cellular connection has been established.
When connecting for the first time, it could take several minutes for the IX10 device to connect
to the cellular network while it attempts to determine the APN required for the connection.
Indicator LEDs blink to show status during startup.
n
Verify that the LTE LED on the front of the IX10 shows either green or blue (solid or
n
flashing) for proper operation.
Verify that the signal strength indicator on the front of the IX10 shows 2 or more bars.
n
Note If your SIM card has an APN that is not recognized by the IX10 device, skip this step and
configure the APN following the procedure at
5. If you intend to configure Ethernet WAN access at this time, use an Ethernet cable to connect
the IX10's WAN/ETH1 port to a hub with access to the Internet.
6. Use an Ethernet cable to connect the IX10 ETH port to your PC.
IX10 User Guide
Apply Dielectric Grease over SIM Contacts
Configure cellular modem APNs.
24