Table of Contents
Advertisement
Digi IX10 Quick start
a. Use a screw driver to remove the SIM slot cover.
b. For high-vibration environments, apply a thin layer of dielectric grease to the SIM contacts.
Note
If the IX10 device is used in an environment with high vibration levels, SIM card
contact fretting may cause unexpected SIM card failures. To protect the SIM cards, Digi
strongly recommends that you apply a thin layer of dielectric grease to the SIM contacts
prior to installing the SIM cards. See
Dielectric Grease over SIM Contacts
c. Insert the SIM card(s) into the SIM sockets. Insert the end of each SIM card with the
chamfered corner positioned as indicated. Push the SIM in until it clicks into place.
d. After SIM cards are installed, replace the SIM slot cover.
Apply Dielectric Grease over SIM Contacts
Note
Digi recommends using either ...the Loctite® LB 8423 Dielectric Grease or Synco Lube®
Silicone Dielectric Grease.
a. Use a sheet of paper or cardboard over the area where you intend to work.
b. Use isopropyl alcohol and a cotton-tipped applicator to gently clean the SIM contacts.
Using isopropyl alcohol requires a well vented environment. Demineralized water can also
IX10 User Guide
Apply Dielectric Grease over SIM Contacts
Apply Dielectric Grease over SIM ContactsApply
for instructions.
23
Advertisement
Table of Contents
