Table of Contents
Advertisement
User authentication
To add the new authentication method to the beginning of the list, use the index value
n
of 0 to indicate that it should be added as the first method:
(config)> add auth method 0 auth_type
(config)>
where auth_type is one of local, radius, tacacs+, or ldap.
To add the new authentication method to the end of the list, use the index keyword
n
end:
(config)> add auth method end auth_type
(config)>
where auth_type is one of local, radius, tacacs+, or ldap.
To add the new authentication in another location in the list, use an index value to
n
indicate the appropriate position. For example:
(config)> add auth method 1 auth_type
(config)>
where auth_type is one of local, radius, tacacs+, or ldap.
You can also use the move command to rearrange existing methods. See
n
position of authentication methods
authentication methods.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete an authentication method
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
IX10 User Guide
(config)> show auth method
0 local
(config)>
User authentication methods
for information about how to reorder the
Rearrange the
585
Advertisement
Table of Contents
