Table of Contents
Advertisement
System administration
Running update pass 1 of 3 ...
Restarting services ...
-----------------------------
Successfully updated firmware
Modem firmware update complete
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Update modem firmware by using a local firmware file
You can update your modem firmware by uploading a modem firmware file to your IX10 device.
Firmware should be uploaded to /opt/MODEM_MODEL/Custom_Firmware, for example,
/opt/LM940/Custom_Firmware.
Modem firmware can be downloaded from Digi here. Follow instructions on this page to determine
the cellular module used by your device. After downloading, use tar or a similar unzipping tool to
extract the firmware prior to uploading to the device. Note that the firmware file may not have a
tar.gz extension, but it is a tar file and can be unzipped with tar or a similar tool. See
command
for information about uploading files to the IX10 device.
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the modem firmware check command to determine if new modem firmware is available
on local device.
> modem firmware check
Checking for latest ATT firmware in flash ...
Newest firmware version available in flash is '05.05.58.00_ATT_005.026_
000'
Modem firmware up to date
05.05.58.00_ATT_005.026_000
> modem firmware check
3. Use the modem firmware list command to list available firmware on the IX10 device.
>
modem firmware list
ATT, 24.01.544_ATT, current
Generic, 24.01.514_Generic, image
Verizon, 24.01.524_Verizon, image
ATT, 24.01.544_ATT, image
Sprint, 24.01.531-B003_Sprint, image
>
IX10 User Guide
Update cellular module firmware
Use the scp
711
Advertisement
Table of Contents
