Table of Contents
Advertisement
System administration
> system backup / type custom-defaults
Backup saved as /opt/custom-default-config.bin
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Locate the device by using the Find Me feature
Use the Find Me feature to cause LEDs on the device to blink, which can help you to identify the
specific device.
To use this feature:
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, click System. Under Administration, click Find Me.
A notification message appears, noting that the LED is flashing on the device. Click the x in the
message to close it.
3. On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the
Find Me feature is active.
4. To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that the LED is no longer flashing on the device. Click
the x in the message to close it.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
IX10 User Guide
Locate the device by using the Find Me feature
720
Advertisement
Table of Contents
