Table of Contents
Advertisement
Services
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source )>
The location source is enabled by default. To disable:
(config service location source )> enable false
(config service location source )>
4. (Optional) Set a label for this location source:
(config service location source )> label "label"
(config)>
5. Set the type of location source to user_defined:
(config service location source )> type user_defined
(config service location source )>
6. Set the latitude of the device:
(config service location source
(config service location source )>
where int is any integer between -90 and 90, with up to six decimal places.
7. Set the longitude of the device:
(config service location source
(config service location source )>
where int is any integer between -180 and 180, with up to six decimal places.
8. Set the altitude of the device:
(config service location source
(config service location source )>
Where alt is an integer followed by m or km, for example, 100m or 1km.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
coordinates latitude int
coordinates longitude int
coordinates altitude alt
Location information
452
Advertisement
Table of Contents
