Table of Contents
Advertisement
Services
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show location information
You can view status and statistics about location information from either the WebUI or the command
line.
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the main menu, click Status.
3. Under Services, click Location.
The device's current location is displayed, along with the status of any configured geofences.
Command line
Show location information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show location
> show location
Location Status
---------------
State
Source
Latitude
Longitude
Altitude
IX10 User Guide
(config service location geofence test_geofence on_exit
action 0)> sandbox false
(config service location geofence test_geofence on_exit
action 0)>
If you disable the sandbox, the script may render the system unusable.
vi. Repeat for any additional actions.
command at the system prompt:
: enabled
: 192.168.2.3
: 44* 55' 14.809" N (44.92078)
: 93* 24' 47.262" w (-93.413128)
: 279 meters
Location information
475
Advertisement
Table of Contents
