Table of Contents
Advertisement
Serial port
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode remoteaccess
(config)>
5. Set the signaling interface type used on this serial port:
rs-232
n
rs-485
n
l
The default is rs-232.
6. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
7. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate rate
(config)>
8. Set the number of data bits used by the device to which you want to connect:
(config)>path-paramdatabits bits
(config)>
9. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
10. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
IX10 User Guide
Enable termination if you want to enable electrical termination on this serial port:
(config)> serial port1 termination true
(config)>
Configure Remote Access mode
169
Advertisement
Table of Contents
