Removing Water From Fuel System; Checking Hydraulic Oil - MacDon M1170NT5 Operator's Manual

Removing Water from Fuel System

DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Open the hood. For instructions, refer to
3. Place a container under filter (A) to catch spilled fluid.
4. Turn drain valve (C) by hand 1 1/2 to 2 turns
counterclockwise until draining occurs.
5. Drain the filter sump of water and sediment until clear fuel
is visible.
6. Turn the valve clockwise to close the drain.
7. Dispose of fluid safely.
8. Close the hood. For instructions, refer to
Hood, page 240.

5.7.3 Checking Hydraulic Oil

The hydraulic system will not work correctly if the hydraulic oil level is too low or too high. It is extremely important to
avoid contamination of the hydraulic system when service and regular maintenance is performed.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
WARNING
Avoid high-pressure fluids. Escaping fluid can penetrate the skin causing serious injury.
1. Park the windrower on a level surface.
2. Lower the header fully.
3. Lower the reel fully.
4. Shut down the engine, and remove the key from the ignition.
215922
MAINTENANCE AND SERVICING
5.3.1 Opening Hood, page
5.3.2 Closing
Figure 5.51: Fuel System
A - Primary Fuel Filter
B - Water in Fuel (WIF) Sensor
C - Drain Valve
272
239.
A
C
B
Revision A