Y Blocks - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
Y BLOCKS
Required Tools
3 mm hex wrench
•
Removal Procedure
Note: Y block removal is the same for both Y blocks. Removal of the model
material Y block is depicted in this procedure.
1.
Unload material.
2.
Power OFF the printer, see
3.
Disconnect material tubes at Y block by loosening the compression fittings and pulling the tubes
outward. See
Figure
Figure 7-42:
"Powering Off" on page
7-42.
Disconnecting Material Tubes from Y Block
169.
Loosen compression
fitting to pull material
tubes outward
200
Advertisement
Table of Contents
