STABILITY WEDGE BLOCKS
1.
Place the Wedge Blocks in position and then snug up the wedge to a gap of 0.25 inch (0.6 cm)
between the system frame and the edge of the wedge.
2.
Use a wrench to tighten the wedges until the top of the wedges are flush with the frame
Snug Fit Before Tightening
Back Wedge Block Placement
Adjacent to the outside of the
skid angle iron mount point
0.25 in.
(0.6 cm)
20
System
Frame
Flush
After Tightening
Wedge Block
(2X)