Table of Contents
Advertisement
Interfaces
Note
To avoid potential problems with access to the device while performing these procedures, you
should use an Ethernet connection connected to LAN1 through the ETH2 Ethernet port, or, if using the
command line, use the serial port.
Task one: Configure bridges
In this task, we will create a new bridge and configure the LAN1 and LAN2 bridges to use the following
devices:
LAN1 bridge:
n
ETH2
l
WWAN cellular modem for single-Wi-Fi models, or WWAN2 cellular modem for dual-Wi-Fi
l
models.
LAN2 bridge:
n
ETH3
l
Digi AP (Wi-Fi2) (applicable to dual-WiFi models only )
l
In task two, we will assign the new LAN2 bridge to a LAN.
TX54 User Guide
Local Area Networks (LANs)
139
Advertisement
Table of Contents
