Digi TX54 User Manual page 143

Interfaces
(config network bridge LAN2)> show network bridge lan2 device
0 /network/device/eth3
1 /network/wireless/ap/digi_ap2
(config network bridge LAN2)>
7. Save the configuration and apply the change:
(config network bridge LAN2)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
Local Area Networks (LANs)
143