Update System Firmware; Manage Firmware Updates Using Digi Remote Manager - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

System administration

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Set a name for the device. This name will appear in log messages and at the command

(config)> system name 192.168.3.1

192.168.3.1(config)>

4. Set the contact for the device:

192.168.3.1(config)> system contact "Jane User"

192.168.3.1(config)>

5. Set the location for the device:

192.168.3.1(config)> system location "9350 Excelsior Blvd., Suite 700,

Hopkins, MN"

192.168.3.1(config)>

6. Set the banner for the device. This is displayed when users access terminal services on the

192.168.3.1(config)> system banner "Welcome to the Digi TX54."

192.168.3.1(config)>

7. Save the configuration and apply the change:

192.168.3.1(config)> save

Configuration saved.

192.168.3.1>

8. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Update system firmware

The TX54 operating system firmware images consist of a single file with the following naming

platform-version.bin

For example, TX54-Dual-Cellular-21.8.24.120.bin.

If you have a network of many devices, you can use Digi Remote Manager Profiles to manage

firmware updates. Profiles ensure all your devices are running the correct firmware version and that

TX54 User Guide

Update system firmware