Table of Contents
Advertisement
Services
n
4. Alternatively, you can use the index number to delete the USB location source:
(config)> del service location 0
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to use a user-defined static location
You can configured your TX54 device to use a user-defined static location.
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Location sources.
4. Click to add a location source.
5. (Optional) Type a Label for this location source.
TX54 User Guide
To disable the module:
(config)> service location source 0 enable false
(config)>
Location information
548
Advertisement
Table of Contents
