Table of Contents
Advertisement
Services
Location information
Your TX54 device can be configured to use the following location sources:
The internal Global Navigation Satellite System (GNSS) module that provides information
n
about the current location of the device.
Dead reckoning, by using an external USB GNSS receiver. External dead reckoning USB
n
GNSS receivers are available to be purchased separately from Digi International Inc.
User-defined static location.
n
Location messages forwarded to the device from other location-enabled devices.
n
By default, both the internal GNSS module and the external dead-reckoning USB GNSS receiver are
enabled.
You can also configure your TX54 device to forward location messages, either from the TX54 device or
from external sources, to a remote host. Additionally, the device can be configured to use a geofence,
to allow you to determine actions that will be taken based on the physical location of the device.
This section contains the following topics:
Configure the location service
Enable or disable the internal GNSS module
Use a dead reckoning external USB GNSS receiver
Configure the device to use a user-defined static location
Configure the device to accept location messages from external sources
Forward location information to a remote host
Configure geofencing
Show location information
TX54 User Guide
Location information
542
544
546
548
550
554
561
573
541
Advertisement
Table of Contents
