Digi TX54 User Manual page 71

Interfaces
12. Optional active recovery configuration parameters:
a. If Reboot device is enabled, for Reboot fail count, type or select the number of times that
the Surelink test must fail before the device is rebooted. The default is 1.
b. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
c. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
d. For Pass threshold, type or select the number of times that the test must pass after
failure, before the interface is determined to be working and is reinstated.
e. For Failed attempts, type the number of probe attempts before the WAN is considered to
have failed.
f. For Response timeout, type the amount of time that the device should wait for a response
to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
13. (Optional) Repeat this procedure for IPv6.
14. Click Apply to save the configuration and apply the change.

Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX54 User Guide
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Wide Area Networks (WANs)
71