Digi TX54 User Manual page 100

Interfaces
3. For single-cellular models, click Network > Interfaces > WWAN or WWAN1.
For dual-cellular variants, there are two WWANs, WWAN1 and WWAN2, which correspond to
each cellular modem. Select the appropriate WWAN, for example WWAN1, click Network >
Interfaces > WWAN1.
4. For Carrier selection mode, select one of the following:
Automatic—The device automatically selects the carrier based on your SIM and cellular
n
network status.
Manual—The device will only connect to the carrier identified in the Network PLMN ID.
n
If the carrier is not available, no cellular connection will be established.
Manual/Automatic—The device will attempt to connect to the carrier identified in the
n
Network PLMN ID. If the carrier is not available, the device will fall back to using
automatic carrier selection.
5. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network
PLMN ID.
Note You can use the
and determine their PLMN ID. See
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
modem scan command at the Admin CLI to scan for available carriers
Scan for available cellular carriers
Wide Area Networks (WANs)
for details.
100