Configure A Wi-Fi Access Point With Enterprise Security - Digi TX54 User Manual

Wi-Fi
b. Set the appropriate radio:
(config)> network wifi ap digi_ap1 radio wifi1
(config)>
10. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
(config)> network wifi ap digi_ap1 encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config)> network wireless ap digi_ap1 encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected see all
broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wi-Fi access point with enterprise security

The WPA2 enterprise security mode allows a Wi-Fi access point to authenticate clients by using one or
more RADIUS servers. When the Wi-Fi access point receives a connection request from a client, it
authenticates the client with the RADIUS server before allowing the client to connect.
Using enterprise security modes allows each client to have different usernames and passwords
configured in the RADIUS server, rather than using preshared key on the TX54 device.
By default, the TX54 device comes with either one or two preconfigured access points:
Single-Wi-Fi models: Digi AP (Wi-Fi).
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2).
n
TX54 User Guide
Configure a Wi-Fi access point with enterprise security
for more information.
Configure a LAN and
238