Digi TX54 User Manual page 291

Hotspot

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Create new access points for the hotspot.
You can also use existing access points for the hotspot. Access Points that are assigned to a
hotspot or to a bridge used by a hotspot cannot be used for any other purpose.
If more than one access point is being used by the hotspot, you must create a bridge that
includes the access points.
a. Create a new access point:
(config)> add network wifi ap new_hotspot_AP1
(config network wifi ap new_hotspot_AP1)>
New access points are enabled by default.
b. Set the Wi-Fi radio for the new access point:
i. Show available radios:
(config network wifi ap new_hotspot_AP1)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
Current value:
(config network wifi ap new_hotspot_AP1)>
ii. Set the appropriate radio:
(config network wifi ap new_hotspot_AP1)> radio wifi1
(config network wifi ap new_hotspot_AP1)>
c. Set the SSID:
(config network wifi ap new_hotspot_AP1)> ssid my_SSID
(config network wifi ap new_hotspot_AP1)>
TX54 User Guide
wifi1
wifi2
Hotspot configuration
291