Digi TX54 User Manual page 619

Services
3. Enable the iPerf server:
(config)> service iperf enable true
(config)>
4. (Optional) Set the port number for the iPerf server listening port. The default is 5201.
(config)> service iperf port port_number
(config)>
5. (Optional) Set the access control list to restrict access to the iPerf server:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service iperf acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service iperf acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the TX54 device:
n
(config)> add service iperf acl interface end value
(config)>
Where value is an interface defined on your device.
TX54 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the service-type.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the service-type.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
Configure the ping responder service
Default IP
Default Link-local IP
619